Sovol SV08 Max

A 500 mm cube is 125 litres — three times the Sovol SV08 it is named after, and by a wide margin the largest build volume in this catalogue. It is also a CoreXY rather than a bed-slinger, which is the only sensible way to move a toolhead across a plate that size at speed. Everything that makes the SV08 interesting carries over — full linear rails, open Klipper with root access, individually available spares — and the bed is scanned by an eddy-current sensor. The enclosure is again optional, and with it the usable height drops to 450 mm; a separate chamber-heating module is sold for it, which is the piece that would make 125 litres of ABS plausible. Unmodified, with a 100 °C bed and no enclosure, this is a very large PLA and PETG machine — and at $1,099 no other CoreXY machine here comes close on volume per dollar.

Approx. price: ~$1,099
Build volume: 125.0 L
Per litre: $9
True multi-material price: No changer offered

Real speed ceiling

625 mm/s

50 mm³/s ÷ (0.4 mm × 0.2 mm) = 625 mm/s. The SV08 Max is advertised at 700 mm/s, so the hotend can feed 89% of the headline figure. An estimate for a straight line at the hotend’s rated flow — real prints are slower again.

LAN-only modeKlipper firmware

Best forThe largest single-piece prints possible on a desktop budget, in PLA or PETG.

Specifications

Build volume: 500 × 500 × 500 mm
Volume: 125.0 L
Motion: CoreXY
Max speed: 700 mm/s
Acceleration: 40,000 mm/s²
Max flow: 50 mm³/s
Hotend max temp: 300 °C
Bed max temp: 100 °C
Enclosure: Open frame
Extruder: direct drive
Auto level: eddy-current
Hardened nozzle: No
Input shaping: Yes

Materials, control and build

Multi-material: None offered
Firmware: Klipper
LAN-only mode: Yes
Cloud: Optional
Camera: Yes
Assembly: Partly assembled
Footprint: 700 × 710 × 750 mm

Features

500 mm cube — 125 litres, the largest here by a wide margin
CoreXY with full linear rails and open Klipper
Optional enclosure kit (reduces height to 450 mm) and a separate chamber-heating module
Eddy-current bed scanning across a 500 mm plate
700 mm/s claimed, with a camera included

What it does well

125 litres at $1,099 is $8.79 a litre, the cheapest litre of any CoreXY machine here
CoreXY geometry, not a bed-slinger, which is the only way a 500 mm plate stays fast
Open Klipper with root access on a machine of this scale
Chamber heating and enclosure are both available as factory modules rather than hacks
Eddy-current scanning is the right levelling method for a plate this large

Where it gives ground

Enclosure and chamber heating are extra, so the base machine is PLA and PETG only
Adding the enclosure costs 50 mm of height
100 °C bed is low for parts 500 mm across, where warping forces are greatest
125 litres takes days to fill even at the published 50 mm³/s
Very new, and a physically enormous machine to house

The points above are read off published specifications, not from owner reports.

What owners report

No owner discussion has been collected for the Sovol SV08 Max yet. Everything on this page comes from the manufacturer’s published specifications and the sources listed under how we compare. We would rather say so than write sentiment we have not read.