Creality Hi

Creality's attempt at an A1 competitor puts a 260 × 260 × 300 mm bed — usefully taller than the 256 mm cubes it is aimed at — on an open bed-slinger frame and hangs the CFS filament system off the side for multi-colour work. The CFS holds four spools with RFID recognition and cascades to four units for sixteen colours, which on paper matches anything Bambu offers. In practice the extra 44 mm of Z is the reason to choose it: tall single-piece prints are exactly what a bed-slinger at this price is for, and 300 mm beats every 256 mm rival here. The rest is conventional — 300 °C hotend, 100 °C bed, Klipper, strain-gauge levelling, no enclosure and no camera. Creality's after-sales reputation is the standing counterargument, and it is the reason the price sits below the machine it is chasing.

Approx. price: ~$329
Build volume: 20.3 L
Per litre: $16
True multi-material price: ~$469

Real speed ceiling

Not published

Creality does not publish a volumetric flow rate for the Hi, so its 500 mm/s claim cannot be checked against what the hotend can actually melt. We do not estimate one.

LAN-only modeKlipper firmware

Best forTall single-piece prints and multi-colour work on an open-frame budget.

Specifications

Build volume: 260 × 260 × 300 mm
Volume: 20.3 L
Motion: bedslinger
Max speed: 500 mm/s
Acceleration: 12,000 mm/s²
Max flow: Not published
Hotend max temp: 300 °C
Bed max temp: 100 °C
Enclosure: Open frame
Extruder: direct drive
Auto level: strain-gauge
Hardened nozzle: No
Input shaping: Yes

Materials, control and build

Multi-material: CFS, 4 slots
True multi-material price: ~$469 (+~$140)
Firmware: Klipper
LAN-only mode: Yes
Cloud: Optional
Camera: No
Assembly: Pre-assembled

Features

260 × 260 × 300 mm — taller than the 256 mm cubes it competes with
CFS four-spool filament system with RFID, cascading to 16 colours
300 °C hotend and Klipper firmware with input shaping
Strain-gauge levelling with automatic Z offset
500 mm/s claimed at 12,000 mm/s²

What it does well

300 mm of height beats every 256 mm cube in this price bracket, which is the whole point of a bed-slinger
CFS matches the four-spool, sixteen-colour capability of much pricier ecosystems
Klipper with input shaping at a genuinely low price
Cheaper than the Bambu A1 it is aimed at, both alone and as a multi-colour combo

Where it gives ground

Creality's support and QC record is the weakest of the major brands here
No enclosure and a 100 °C bed, so the 300 °C hotend is under-used
No camera at a price where rivals include one
No published flow rate to check the 500 mm/s claim against
A big bed slinging in Y at 12,000 mm/s² is a demanding combination for ringing

The points above are read off published specifications, not from owner reports.

What owners report

No owner discussion has been collected for the Creality Hi yet. Everything on this page comes from the manufacturer’s published specifications and the sources listed under how we compare. We would rather say so than write sentiment we have not read.